Applicable to 16-21 Tesla MODEL3 car tire fender modified front and rear wheels

Description

Product size: front wheel 200 mm * 270 mmThe rear 195 mm * 290 mmPacking size: 315 mm * 90 mm * 200 mmThe product gross weight: 0.64 kgNet weight: 0.48 kgProduct color: blackProduct material: PP soft plasticProduct process: moulded plastic injection moldingLocation: round rearAccessories products: screws, packing box, a set of fender (4)
Our
Model 3 Mud Flaps
would be a nice addition to tesla model 3,not only protects the lower part of car but also gives a nice look to the car.
For More Question and Answer:
Q: Do these mud flaps fit for 2019 Model 3?
A:Yes,it fit for all model 3 vehicles.
Q:Do these require any holes to be drilled into the car?
A:Yes,you have to drill very small holes for the front two (two holes in total), but they are in the thin plastic liner of the wheel well. You wouldn’t notice them if you were to remove the splash guards.
Q:Will the design block the drain area just above the rocker panel and below the front fender?
A:No, there is a place to drain any water.
Q:Did this cause any change in range?
A:No drop in range after driving 2,000 miles on a road trip with the Model 3 Performance.
Installation Tips from Tesla Owner:
1.For the front flaps, pop out the pop-rivets that are in the car already. Line up the mud flap, then put in the bottom part of the new (included) pop rivets first. Then push in the top part of the pop-rivet. You may need to pre drill the one screw for each front mud flap. Use the smallest drill bit you have. This will make screwing in the screw much easier.
2.For the rear flaps, remove the pop-rivet and the 10mm bolt under the rear bumper. Line up the mud flap and make sure to seat it against the rear bumper. Then push in the new pop-rivet and reinstall the 10mm bolt.